Thermal Bridge Heat Transfer & Vapour Diffusion Simulation Program AnTherm Version 6.115 - 8.133 

[ ← ] [ ↑ ] [ → ] [ToC]

Axes (control panel)

The control panel Axes is used to adjust setting of the axes representation shown around the three dimension view of evaluation combination.

Active, Opaque Decide about the visibility and transparency of the axes lines and their annotations.
Placement At Outer Edges - axes will be placed at  outer edges of the volume
or
At Closest Triad - axes will be placed at the corner which is closest to the viewer.
Titles Decide about the visibility of titles on all three axes (e.g.. X, Y, Z)
Font Size [pts]
 
Defines the size of the font used to show axes titles.
 
Labels Decide about the visibility of numerical labels on axes.
Font Größe
 
Defines the size of the font used to show numerical labels on axes.
 
# intervals Defines the number of intervals of numerical labels on all three axes.
   
X Aktiv Decide about the visibility of X axis and its annotations.
X Titel Decide about the visibility of an axis tile on X axis.
Titel Defines the title of X axis
X Labels Decides about the visibility of numerical labels on X axis.
   
Y Aktiv Decide about the visibility of Y axis and its annotations.
Y Titel Decide about the visibility of an axis tile on Y axis.
Titel Defines the title of Y axis
Y Labels Decides about the visibility of numerical labels on Y axis.
   
Z Aktiv Decide about the visibility of Z axis and its annotations.
Z Titel Decide about the visibility of an axis tile on Z axis.
Titel Defines the title of Z axis
Z Labels Decides about the visibility of numerical labels on Z axis.

By default axes are shown with numerical labels and titles. The colour of axes lines and annotations is chosen automatically and set to some high contrast colour against current background colour.

Axes lines are settled a bit out of the volume shown allowing sufficient space for numerical labels. The position of each axis is adjusted according to the placement chosen (so called "Fly-Mode" method) - for each axis there are 4 different placement alternatives at 4 sides of the Outline of the volume).

Remark: During 2D evaluations and with views parallel to axes planes (side views) it is advised not to select "At Outer Edges" - otherwise axes will jump between left/right and bottom/top edges because the term "outer" is ambiguous (and numerically unstable thereafter)

Remark: Naming of axes titles can be adjusted in application settings also.

See also: Results 3D window, Active (setting), Background colour (setting), 3-D Navigation Orientation Marker (control panel), Application settings


 Model, Calculate, Simulate and Analyse Thermal Heat Bridges in 2D and 3D with AnTherm®  

[ ← ] [ ↑ ] [ → ] [ToC

 Copyright © Kornicki Dienstleistungen in EDV & IT

2017-03-22 10:19 +0100